Every 3D printing process has a build volume, and every large project runs into it eventually. At that point there are two options: split the part into sections and join them, or find a process that prints it whole. Both are legitimate. The right one depends on what the part has to do.

Where the limits sit

Build limits vary a lot between services. Protolabs lists 29 x 25 x 21 in (736 x 635 x 533 mm) as its largest SLA build, in ABS-like resins. Xometry lists parts up to 24 x 36 x 36 in without the need to split and bond. Makelab's Industrial SLA prints up to 67 x 31 x 24 in (1700 × 800 × 600 mm), and our FGF large-format printers go up to 94 x 94 x 39 in (2400 × 2400 × 1000 mm).

So a 40 in housing is a split part at some services and a single print at others. Check the limit for the process and material you need before you design around it.

When a split is fine

Splitting is often the right call. It works well when:

  • The part is a display model or prop, and the seam can sit on a hidden face or a natural break line.
  • Splitting lets each section print in a better orientation, with fewer supports on cosmetic faces.
  • The sections need different materials or finishes anyway.
A good split is planned in CAD. Put the joint on a flat face or along a feature line, add alignment pins or a tongue and groove so the sections register, and leave room for adhesive. Our design guidelines list the clearances to leave between mating parts for each process.

When a seam causes trouble

A seam breaks the material, and on some parts that matters:

  • Load. A bonded joint is usually weaker than the material around it. If a bracket or frame carries load across the joint, the joint sets the strength.
  • Sealing. An enclosure that has to hold air or water depends on a continuous wall, and every seam is a possible leak path.
  • Finish. On a glossy painted part, a seam can show through the paint.
  • Tolerance. Each joint adds a little error. Over a long part, small offsets add up to a bow or a hole pattern that misses.
If any of these apply, a one-piece print is worth looking for before you accept the split.

What one piece looks like at large sizes

Industrial SLA prints large parts with a smooth resin surface, which suits housings, design models and display pieces that will be painted. FGF extrudes pelletized ABS at industrial scale, for oversized prototypes, molds and fixtures. The tradeoffs are the usual ones for each process: FGF holds ±1.0mm with a 4.5mm minimum wall, so it is a better fit for big structural parts than for fine detail.

Large parts also take longer. At Makelab, Industrial SLA lead times run from 7 business days and FGF from 7 business days, against FDM from 1 business day.

Questions to ask before you split

  • What is the largest one-piece size, in inches, for the process and material I need?
  • If it has to split, where would you put the joint, and how would you align and bond it?
  • Can I see the split plan before it prints?

Where Makelab fits

Large plastic parts are where Makelab differs most from Protolabs. Our Industrial SLA builds up to 67 x 31 x 24 in (1700 × 800 × 600 mm) in one piece, more than twice the length of Protolabs' largest SLA build, and FGF goes to 94 x 94 x 39 in (2400 × 2400 × 1000 mm). When a part does need sections, you work out the split with the engineers who print it. The instant quote checks part size as you upload, so you know right away whether a part fits a build.

Read the full comparison in Makelab vs Protolabs, or see our large format 3D printing service. To check your part, upload it at quote.makelab.com.